• Final Regulation (pdf) (This is the final Federal regulation dated 03/21/2011)
• Proposed Notice (pdf) of Selected Reconsiderations (This is the Federal proposed notice to reconsider certain portions of the final regulation dated 03/21/2011)
• Fact Sheet (pdf) (This is a detailed

• General Guidance 
• Boilers 
• Chemical Manufacturing 
• Gasoline Dispensing 

• Final Regulation (pdf) (This is the final Federal regulation dated 10/29/2009)
• Fact Sheet (pdf) (This is a detailed fact sheet describing the regulation)
• EPA Brochure (pdf) (This is the Federal brochure describing the Federal regulation)
• Initial Notification (doc) (

Revised Regulation 61-62.1, Section III - Emissions Inventory (pdf) (Effective 8/25/2017)
Note: Emissions from non-fugitive and fugitive sources (excluding vehicle engine emissions) are to be used when determining a facility's "Inventory Source Type" and when reporting a facility's emissions to comply with this Regulation.

Do I need to do an Emissions Inventory? (pdf)

SLEIS

Emission Estimating Tools

Multisource Test Calculator Tool (xls)
Spreadsheet template that assists in calculating emissions using results of a Department-approved source test. Please note that all templates are examples for use at your discretion only. Feel free to download & modify for your needs

Emissions Inventory reporting is required by Regulation 61-62.1 Section III and condition 4.B.6 contained in Part 4.B of a facility's Title V permit if the permit was issued before 10/09/2007; condition 4.6 contained in Part 4 of a facility's Title V permit if the permit was issued between 10/09/2007 and 10/14/2008; or condition 4.3 contained in Part 4 of a facility's Title V permit if the permit was issued after 10/14/2008.

What Does the Technical Management Section (TMS) Look for in Reporting?

The TMS looks for four basic elements in reporting: timeliness, completeness, accuracy, and compliance status.

Timeliness - Most periodic reports must be postmarked no later than 30 days after the end of the reporting period. TVACC's must be postmarked no later than 45 days after the end of the reporting period.

Completeness - The facility must submit all of the data required by the permit condition, in the correct format.

The following forms were created to assist facilities with reporting required by construction or operating permits. Use of these forms is not mandatory. These forms are intended for guidance purposes only and may not be applicable to all facilities. Some forms require manipulation so that spreadsheets represent materials used at your facility.

Please click on the check marks to download the desired form in the table below.